Balancing valve for solar systems with a flow meter that can be read directly,
consisting of a float body and counter spring.
Flow meter for solar systems and heating systems.
Connection thread: external 1"
The balancing valve is commonly used in systems where a specific user's
flow rate needs to be regulated or a circuit needs to be balanced.
Its simple operation allows any operator in the industry to set the correct water flow
required for each individual user or for the project to achieve circuit
balance by directly operating the valve.
Body: Brass CW617N - EN12165,
Ball: Brass CW617N - EN12164,
Shaft: Brass CW617N - EN12164,
O-rings: ethylene propylene rubber EPDM,
Spring: steel,
Indicator: high-performance plastic.
Technical characteristics
Maximum working temperature: 100°C,
Maximum working pressure: 10 bar,
Thread: external thread ISO 228/1,
Measurement accuracy: +/- 10%.
The valve can be installed in horizontal, inclined or vertical pipes.
Use a screwdriver to turn the adjustment screw until
you can read the desired flow rate directly on the valve.
If deposits (dirt) are detected inside the valve, it is necessary to stop the flow
in front of the valve and close the valve itself by operating the adjusting screw.
Then clean the valve, restore the flow and adjust according to the previous settings.
Graduated price:
1 - 4 pieces = € 60.14 / piece
more than 4 pieces = € 59.79 / piece
The data sheet with the assembly instructions can be found in "Media".
Pressure conditions. Please note the right diagram!
Dimensionen:
Link to product:
https://www.tiemme.com/deu/contabilizzazione/6531g_contabilizzazione-det_9619.php